Fault finder: Alarm with latch memory

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Starts on at power up: what should I check?

Normal, the latch may power up either way. Press reset.

Never latches: what should I check?

The cross-coupling wires are crossed wrongly. Re-check pins 3, 5, 6 and 2.

Buzzer too quiet: what should I check?

The BC547 base resistor is too large or the buzzer needs 5 V.

Works with the magnet backwards: what should I check?

Fine, the reed only needs the magnet close.