Fault finder: Solar spice and fruit dryer fan control

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nano resets: what should I check?

The 5 V converter is set too low or the panel is shaded.

Fan always on: what should I check?

Check the sensors and the humidity limits, and the MOSFET pull-down.

Fan never starts: what should I check?

Check the 12 V converter and the gate wire.

Wrong readings: what should I check?

Keep the inside sensor away from the fan's airflow shadow.