Fault finder: Speed of sound and temperature

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No echo or probe: what should I check?

Check the Trig and Echo wires and the probe wiring and pull-up.

Result is far off: what should I check?

Measure the distance again and set DISTANCE_M.

Numbers scatter: what should I check?

Use a flat wall, keep the sensor still and avoid clutter.

Probe reads minus 127: what should I check?

Check the three probe wires and the resistor.

Display blank: what should I check?

Check the OLED address 0x3C.