Fault finder: Solder joint timer
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No beeps: what should I check?
Use a passive buzzer on D8.
Button seems ignored: what should I check?
Check D2 to GND.
Result prints at once: what should I check?
A bounce, increase the 40 millisecond lockout.
Times feel wrong for your joints: what should I check?
Adjust GOOD_FROM, GOOD_TO and LIMIT.
LEDs stay on: what should I check?
The second press ends the joint and turns them off.
