Fault finder: Solar panel I-V curve tracer
9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Current stays zero: what should I check?
Check the common ground and the op-amp power.
Oscillating readings: what should I check?
Keep the 1 k gate resistor and short leads.
Negative current: what should I check?
Swap the INA219 VIN+ and VIN- wires.
