Projects / Solar dryer logger / Fault finder

Fault finder: Solar dryer logger

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Red light at start: what should I check?

Check the card is FAT32 and the module is wired to D10 to D13.

Red light after a while: what should I check?

A sensor did not answer, check its data wire and pull-up.

Wrong time: what should I check?

Re-upload after removing the clock's cell for a moment, or set the clock.

Empty file: what should I check?

Wait a minute for the first line, and close the file before removing the card.

Readings stuck: what should I check?

Check the sensors are not swapped and have 5 V.