Fault finder: Read your electricity meter's LED
7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No pulses: what should I check?
Adjust the pot and check the photodiode direction.
Too many pulses: what should I check?
Block room light and raise the threshold.
Power wrong: what should I check?
Check the imp/kWh figure on the label.
MQTT silent: what should I check?
Check the broker address and port.
