Fault finder: Window sensor that stops the AC

8 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing captured: what should I check?

Receiver wired to the wrong pin, or the remote is out of line of sight.

AC does not react: what should I check?

LED not pointed at the AC, or the protocol is not replayed by raw timing.

LED seems dim: what should I check?

Check the transistor orientation and use a phone camera to see IR flashing.

Sent at the wrong moment: what should I check?

Reed switch on the wrong side of the magnet; swap the logic.

ESP32 resets when sending: what should I check?

Power it from a good USB supply.