Fault finder: Bedroom fan that follows the night

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Fan will not start: what should I check?

Raise the minimum percentage.

Whine: what should I check?

Check the 25 kHz setup on pin D9.

Wrong time: what should I check?

Reset the RTC with the example sketch.

Reads nan: what should I check?

Check the DHT pull-up and wiring.