Fault finder: Smart air freshener
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Servo twitches: what should I check?
Add the capacitor and use a proper 5 V supply.
Never sprays: what should I check?
Print the timers. The PIR may need warm-up time or the room sensor view is blocked.
Presses too weakly: what should I check?
Change the servo angle and mount it closer.
Sprays count is wrong: what should I check?
Reset the EEPROM value when you fit a new can.
