Fault finder: Whole-room energy meter with PZEM-004T

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No readings: what should I check?

Check TX and RX are not swapped and the module has 5 V.

Garbled values: what should I check?

Check the baud rate and the level of the TX line.

Current reads zero: what should I check?

Check the clamp is closed and around the live wire only.