Fault finder: Touchless smart dustbin
8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
The lid opens by itself: what should I check?
The sensor sees the bin rim or a wall. Tilt it outwards or lower the 20 cm limit.
The servo buzzes when closed: what should I check?
CLOSED pushes past the stop. Raise it from 0 to 5 or 10.
The Uno resets when the lid moves: what should I check?
The servo is powered from the Uno. Use the separate AA pack with a shared ground.
Distance always 999: what should I check?
TRIG and ECHO swapped, or ECHO not on D10.
