Fault finder: Compost pile temperature monitor
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Probe error: what should I check?
Pull-up missing or wires swapped.
Reading much lower than expected: what should I check?
The probe is near the edge. Push it deeper.
Display shows only the start: what should I check?
It refreshes every 30 minutes. Reduce INTERVAL to test.
Batteries die: what should I check?
The Nano board draws idle current. Use a USB power bank or a larger battery pack.
