Fault finder: Slot car or toy car lap timer

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts several times per pass: what should I check?

The car is long and triggers it more than once. The 0.3 s lockout hides this, so raise it for a longer car.

Never counts: what should I check?

Sensor range too short or it is pointing the wrong way. Adjust the trimmer.

Times are wrong: what should I check?

Check the lap is measured from the same line. Both sensors must be at the finish line.

LCD blank: what should I check?

Check the I2C address and contrast.