Fault finder: Single-axis solar tracker

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Turns away from the light: what should I check?

Swap the A0 and A1 wires, or swap angle-- and angle++.

Hunts back and forth: what should I check?

Raise DEAD to 40, or make the shade wall taller.

Servo too weak in wind: what should I check?

Use a lighter panel and a balanced mount, or a geared motor.