Fault finder: Knight-rider LED chaser

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LEDs light: what should I check?

Check pin 16, pin 8 and pin 13 and the LED direction.

Wrong LED order: what should I check?

Check the output pin order QA to QH.

Random flicker: what should I check?

Pin 10 or pin 13 is floating, tie them as shown.

Chip warms up: what should I check?

Too many LEDs lit at once, use larger resistors.

Sweep too fast to see: what should I check?

Raise the delay range in stepDelay().