Fault finder: Analog IR distance meter

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings jump: what should I check?

Add the capacitor close to the sensor.

Always out of range: what should I check?

Check the Vo wire on A0 and the supply.

Distances too large or small: what should I check?

Your sensor model has a different curve, fit your own.

Wrong colours of wire: what should I check?

Check the label on the connector.

Display blank: what should I check?

Try address 0x3D instead of 0x3C.