Fault finder: Seven-segment direct drive test

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

Check the common pin goes to GND, not 5V.

A segment never lights: what should I check?

Check its resistor and the wire to the pin.

Digits look wrong: what should I check?

Your pins may be in a different order, check the sweep.

Display is a common anode type: what should I check?

Join the common pin to 5V and invert the pattern in code.

Button skips two digits: what should I check?

Hold it only briefly.