Fault finder: Three-channel servo tester

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servos jitter or the Nano resets: what should I check?

Power the servos from the external supply, not the Nano.

Nothing moves: what should I check?

Join the grounds of the supply and the Nano.

Servo hits the end and buzzes: what should I check?

Narrow the range, for example 1100 to 1900 us.

One servo does not respond: what should I check?

Check its signal wire is on the right pin.

Servo drifts at centre: what should I check?

The centre of some servos is not exactly 1500 us, adjust a little.