Fault finder: Servo sweep and calibration
10 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Servo jitters: what should I check?
Add the capacitor or use a separate 5 V supply.
Buzzes at an end: what should I check?
Narrow the pulse limits.
Does not move: what should I check?
Check the signal pin 9 and the ground connection.
Uno resets: what should I check?
The servo draws too much; use an external supply.
