Fault finder: Servo pulse width reader

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reader prints nothing: what should I check?

Join the grounds and check the D9 to D2 wire.

Servo jitters or board resets: what should I check?

Use a smaller servo or a separate battery pack with a common ground.

Widths look half or double: what should I check?

Check you read HIGH pulses on the right pin.

Servo does not move: what should I check?

Check the three servo wires.

Angle guess is off: what should I check?

Your servo range may differ from 1 to 2 ms.