Fault finder: Knob-controlled servo

10 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo jitters or the board resets: what should I check?

Add the 100 µF capacitor, or power the servo from a separate 5 V supply with a shared GND.

Servo does not move: what should I check?

Check orange goes to D9 and arm.attach(9) matches.

Angle only covers half the range: what should I check?

Check the pot's outer pins go to 5V and GND, not 3.3V.