Fault finder: Serial debug console
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No reply: what should I check?
Line ending set to No line ending: choose Newline.
Garbage text: what should I check?
Baud rate mismatch: both must be 115200.
Commands ignored when typed fast: what should I check?
Lines over 40 characters are cut; keep them short.
