Fault finder: Serial baud rate detector

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always No signal: what should I check?

Check the data wire and the shared ground.

Wrong rate reported: what should I check?

Make sure the sender sketch is running and the pin is D3.

Sender garbles at high rates: what should I check?

SoftwareSerial is best at 19200 baud and below.

Numbers jump about: what should I check?

Wait for the sender to settle after a speed change.

Upload fails: what should I check?

Choose the Old Bootloader option.