Projects / Plug-in sensor tray / Fault finder

Fault finder: Plug-in sensor tray

13 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo twitches: what should I check?

The USB supply sags, power it from the Vin jack or a separate 5 V supply.

LDR value never changes: what should I check?

Check the divider is on A0 and the resistor goes to ground.

Button reads 1 all the time: what should I check?

Check the wiring to ground and the pull-up in the sketch.

Servo does not move: what should I check?

Check the plug direction and that D9 is the signal pin.

Upload fails: what should I check?

Remove the shield briefly and try again.