Fault finder: Two-point sensor calibration

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

DS18B20 reads -127: what should I check?

Check the 4.7 kΩ pull-up and wiring.

TMP36 noisy: what should I check?

Averaging is in the code; add a 100 nF capacitor on the output.

Corrected is worse: what should I check?

Check RAW and REF values are not swapped.

Water short circuit: what should I check?

Keep the sensors sealed in a bag.