Fault finder: Two-wheel self-balancing robot

14 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 14 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 14

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Falls over fast in one direction: what should I check?

The motors push the wrong way. Swap both motor's wires, or use motors(-out).

Shakes violently: what should I check?

Kd too low or Kp too high. Lower Kp, raise Kd.

Slowly drives off and falls: what should I check?

Setpoint is off the true balance point, or Ki is zero.

Resets when motors kick: what should I check?

Weak cells or the Nano is on the motor supply. Use the buck converter and charged cells.