Fault finder: Bike lock tamper alarm

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Siren never starts: what should I check?

Sensor sensitivity screw on the SW-420 too low; turn it until it triggers on a firm tap.

Siren starts at random: what should I check?

Too sensitive; turn the screw the other way.

Upload fails: what should I check?

Check the ISP wiring and the 10 uF capacitor trick between Uno RESET and GND during upload.

Chip does not wake: what should I check?

Pin-change mask or wiring; confirm the sensor is on pin 7 (PB2).

Buzzer weak: what should I check?

Normal at 4 V; try a 5 V active buzzer.