Fault finder: Salinity meter for aquariums and salt pans
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Reading drifts: what should I check?
Rinse the electrodes and check the polarity switching.
Always maximum: what should I check?
Electrodes touching or shorted.
Low accuracy: what should I check?
Fix the electrode gap and calibrate at two strengths.
Corroded screws: what should I check?
Use proper stainless and rinse after use.
