Fault finder: SD card data logging lab
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
SD card failed: what should I check?
Check the wiring, FAT32 format and CS pin 10.
RTC not found: what should I check?
Check A4 and A5 and the module power.
Times wrong: what should I check?
Set the RTC with the library example.
NaN readings: what should I check?
Check the DHT22 pull-up resistor.
