Fault finder: Schmitt trigger with hysteresis

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check the LED direction and that the pull-up sits on pin 1.

LED always on: what should I check?

Check the reference divider gives about half supply on pin 2.

Still chatters: what should I check?

Check the feedback goes to pin 3, not pin 2, and use a smaller resistor.

Strange readings: what should I check?

A meter on the high-value divider loads it a little, so read quickly.