Fault finder: Sample and hold circuit

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output never changes: what should I check?

Check the clock on pin 13 and the switch pins.

Output follows the input all the time: what should I check?

The control pin is stuck high or the clock is too fast.

Output droops fast: what should I check?

The hold capacitor is too small or leaky.

Output stuck near 0: what should I check?

Check the follower wiring on the LM358.