Fault finder: Ladder tilt alarm
6 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Beeps constantly: what should I check?
X axis is not along the rail. Remount or change the axis in the code.
Never beeps: what should I check?
Check the buzzer wiring and that D10 matches the pin used.
Wrong angle: what should I check?
Check the sensor orientation and that the X arrow points up.
Will not wake: what should I check?
Tip it above 20 degrees within 5 seconds of a wake check.
