Fault finder: Hot plate warning light

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading is nan: what should I check?

Check the thermocouple is plugged in with the right polarity.

Always zero: what should I check?

Check the SO, CS and SCK wires.

Reading jumps: what should I check?

Keep the module away from the hot surface and wires apart.

Lamp stays dim: what should I check?

Check the resistor and the PWM pin 9.