Fault finder: Small speaker driver with a transistor
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No sound: what should I check?
Check the transistor orientation and the base resistor.
Very quiet: what should I check?
Check the speaker connections and turn the knob up.
Distorted: what should I check?
Normal for a square wave, lower the volume.
Transistor hot: what should I check?
The 47 ohm resistor is missing or the pins are wrong, unplug at once.
Nano resets: what should I check?
Power from a better USB port.
