Fault finder: Speedcube stack timer

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Timer starts too early: what should I check?

One pad releases briefly. Add a tiny delay or use the TTP223 latch jumper settings correctly.

Pad does not respond: what should I check?

Cover is too thick or the module is not powered. Test the module's LED.

Display shows weird digits: what should I check?

CLK and DIO swapped.

Pads trigger without touch: what should I check?

Electrical noise near the Nano. Keep the touch wires short and grounded.