Fault finder: RS-232 to Wi-Fi bridge
5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No data: what should I check?
Swap TX and RX or use a null-modem cable.
Garbled data: what should I check?
Match baud rate and parity to the manual.
Cannot connect: what should I check?
Check the IP address and that the PC is on the same network.
Missed data: what should I check?
Increase the buffer or lower the instrument's rate.
