Fault finder: Rotary encoder settings box

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Menu moves the wrong way: what should I check?

Swap the CLK and DT wires, or change the sign in onTurn.

Steps skip or double: what should I check?

Increase the 2 ms bounce limit, or add a 10 nanofarad capacitor from CLK to GND.

Display blank: what should I check?

Try address 0x3D, and check the display voltage.

Settings do not survive power-off: what should I check?

Check saveSettings is called when you press the knob to finish editing.

LED never lights: what should I check?

Check the LED direction and that brightness is above 0.