Fault finder: Room occupied door sign
8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Always red: what should I check?
Turn down the sensitivity and keep the sensor away from heaters.
Never red: what should I check?
Check PIR OUT on D2 and 5 V on the PIR.
Goes green while someone sits still: what should I check?
Make the hold time longer in the program.
LED never lights: what should I check?
Check the leg direction and the resistors.
Flickers at start: what should I check?
It is still settling, wait a minute.
