Fault finder: Rodent trap alert for godowns

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No message: what should I check?

Antenna missing, wrong data pins or the receiver is too far.

Trap node wakes randomly: what should I check?

The reed is bouncing. Move it or add a debounce delay.

Receiver hears noise: what should I check?

433 MHz receivers pick up interference. Check the length and ID before acting, as in the code.

Battery lasts days only: what should I check?

The Nano board draws idle current. Use a bare chip for long life.