Fault finder: Four-servo robotic arm with knobs
12 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Servos twitch: what should I check?
The pot has noise. Add a 0.1 µF capacitor from each wiper to GND or average readings.
Uno resets when servos move: what should I check?
The servos are on the Uno 5 V pin. Use the AA pack.
Gripper stalls and buzzes: what should I check?
Its limits are too wide, so it pushes against its stop. Narrow MINA and MAXA.
Recording stops early: what should I check?
The 100-frame buffer is full. Reduce the frame rate or shorten the move.
