Fault finder: Sumo robot with front ToF array

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Drives off the ring: what should I check?

Check the edge comparison direction and level.

Sensors not found: what should I check?

Check XSHUT wiring and addresses.

Motors too fast: what should I check?

Lower SPD.

Resets under load: what should I check?

Check the supply wires and capacitor.