Fault finder: Obstacle-avoiding robot

10 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Spins in circles: what should I check?

One motor wired backwards: swap its wires.

Uno resets on start: what should I check?

Motors on the Uno's 5 V: use the battery for VM.

Hits chair legs: what should I check?

Thin objects reflect poorly; mount the sensor higher or add a second one.