Fault finder: Control a robot arm from a computer game controller

8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servos jitter or the Uno resets: what should I check?

Servo power from the Uno; use the AA holder, shared GND, and the capacitor.

Port busy error: what should I check?

Close the Serial Monitor.

No controller found: what should I check?

Plug it in before starting; try pygame.joystick.get_count().

Wrong stick moves a joint: what should I check?

Axis numbers differ; print them and change the code.

Arm slams to one end: what should I check?

Start with all joints commanded to 90 before fitting the arms.