Fault finder: RFID name tag reader

6 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reader not detected: what should I check?

Check the 3.3 V supply and the SPI wiring.

Tag ID not matching: what should I check?

Compare the serial monitor output exactly, uppercase and no spaces.

Display blank: what should I check?

Try address 0x3F and adjust the contrast screw.

Reads are intermittent: what should I check?

Hold the tag flat and within three centimetres.

Library error: what should I check?

Install MFRC522 from the Library Manager.