Fault finder: RFID door log
8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Nothing happens on tap: what should I check?
Check SDA is on D10 and RST on D9, and the module has 3.3 V.
Works then stops: what should I check?
Loose SPI wires are common: use short wires and press them in firmly.
Every card is refused: what should I check?
Copy the ID exactly as printed, 4 bytes, into allowed[].
