Fault finder: Ohmmeter for loose resistors

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always No resistor: what should I check?

Check the unknown resistor goes from A0 to GND.

Readings jump: what should I check?

Use firm clips, and keep fingers off the leads.

Low ohms read wrong: what should I check?

The pin resistance matters, check the 25 ohm figure.

High values read low: what should I check?

Skin touching the leads adds a parallel path.

Display blank: what should I check?

Try address 0x3D, and check the display voltage.