Fault finder: Regulator efficiency study

10 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Buck output stuck at input voltage: what should I check?

Input too low for the set output, or the module is faulty.

INA219 reads 0: what should I check?

It must be in series, not across the supply.

Load resistors hot: what should I check?

Use a proper load or shorter tests: 5 V across 110 Ω is 0.23 W.