Fault finder: Reed switch door chime

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Chimes all the time: what should I check?

The magnet is too far from the switch when closed, or the wires are loose.

Never chimes: what should I check?

Swap the switch wires to check them or test with a jumper to GND.

Chimes twice: what should I check?

Raise SETTLE_MS or QUIET_MS.

Buzzer silent: what should I check?

Check it is a passive buzzer and the plus wire is on D8.

Chimes when you touch the wires: what should I check?

Keep the wires short and fixed.