Fault finder: Touch-dimming reading lamp

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Lamp on at start: what should I check?

Check the gate pull-down.

Flicker: what should I check?

Check the Timer 1 line is present.

Touch not detected: what should I check?

Check the module VCC and its OUT wire.

MOSFET hot: what should I check?

Check the strip current and that the gate gets a full 5 V.